Monthly Archives: November 2015

Finding a lost model with Taranis ( or other ) Telemetry

Some time ago Bruce Simpson of RC model Reviews mentioned using the Taranis Telemetry to find a lost model. I have used it several times lately so thought I would pass on this tip.

The idea is that the lowest signal is when your antenna is pointed directly at the model – which is why you fly with the antenna at 90 degrees ( did you know that ? )

If you have a telemetry enabled receiver ( a RX battery voltage display is a good indicator ) then you can get the Taranis to display the strength of the telemetry signal from the RX to the TX. This is known as the RX RSSI.

If you stand with the antenna pointed straight out and slowly rotate 360 degrees then when the signal is at its lowest you are facing directly towards or directly away from your model ( slight rub there ).

The screen below shows the default RX RSSI

2015-11-27_20-31-44

 

You can add a more useful RSSI reading to the telemetry screen using Companion as shown below

2015-11-27_20-32-35

2015-11-27_20-32-59

As you get closer to the model you may need to enable range check mode to reduce the signal strength to see a discernible difference. In this case it is the RSSI in the pop up window that you use to gauge the signal strength.

2015-11-27_20-57-09

This method also works on other Telementry enabled transmitters. I helped a club mate with a very posh Jeti transmitter to find a model last week but the Jeti has 3 4 antenna built into the handle so the directional aspect was not as good. He did find the model by walking around until the signal peaked and then going to range check mode to narrow it down further.